The hot sun, the word "hot", high temperature and heat wave repeatedly baked "test machine, those frequently used parts and functions are very prone to problems, so timely repair is necessary, today Xiaobian to tell you is under high temperature roller sprinkling water tank use precautions.
Roller sprinkling water tank plays an important role in cooling and heat dissipation. In the summer of continuous high temperature, the water tank is especially prone to some small failures, the water level is insufficient, water tank corrosion, leakage and so on will directly cause "boiling pot", that is, the temperature of the water tank reaches the boiling point. At this time, the engine heat dissipation is poor, the temperature is too high, the expansion of parts will reduce the clearance of each part, on the other hand, the temperature is too high, the oil viscosity is reduced, in this case, the wear of each part is aggravated. If not immediately appropriate treatment, the engine is likely to lead to serious damage accidents, so remind you friends, the basic maintenance of the roller, or pay attention to.
When the water temperature of the roller asperses the water tank is too high, we must not be in a hurry, which is easy to bring a certain degree of damage to ourselves and the engine. We must remember that these three do not:
1, do not try to continue to drive the roller, so as not to cause large damage accidents.
2. Do not try to open the tank cover, otherwise it is likely that hot liquid will squirt out and cause burns.
3, do not pour cold water on the engine cylinder block, cylinder head, otherwise it is likely to cause the cylinder block due to sudden cooling and crack.
The above three points please friends must remember, otherwise it is too late to bring harm to you or your roller.
Sprinkling water tank use matters needing attention: when water is released completely inside radiator to inject water again, turn the water switch of engine cylinder block to open first, when water flows out, close again, avoid producing blisters thereby. In daily use, the water level should be checked at any time, and water should be added after cooling down. When adding water, slowly open the tank cover, and the operator's body should be as far away from the water adding port as possible to prevent high pressure steam from the water adding port resulting in scald.