The hot sun, talking about the maintenance of the water tank of the roller

Scorching sun, "hot" word, high temperature and heat wave repeatedly baking "test love machine, those frequently used parts and functions are very prone to problems, so timely repair is necessary, today xiaobian to tell you is under high temperature roller sprinkle water tank use precautions.

Sprinkler water tank of road roller plays an important role in cooling and heat dissipation. In the summer of continuous high temperature, cistern gives a few small faults especially easily, water level is insufficient, cistern rust, leakage can cause directly "boiling pot", namely cistern temperature reaches boiling point. At this time, the engine heat dissipation is poor, the temperature is too high, and the expansion of parts will reduce the coordination gap of each part. On the other hand, the oil viscosity is reduced when the temperature is too high. In this case, the wear of each part is intensified. If not immediately for proper treatment, the engine is likely to lead to serious machine damage accidents, so remind you, roller basic maintenance, or to pay attention to.

The hot sun, talking about the maintenance of the water tank of the roller

When the water temperature of the sprinkler water tank of the roller is too high, we must not be in a hurry, which is easy to bring a certain degree of damage to ourselves and the engine. We must keep in mind the three do not:

1, do not try to continue to drive the roller, so as not to cause large machine damage accident.

2, do not try to open the water tank cover, otherwise it is very likely to have hot liquid spray resulting in burns.

3, do not pour cold water to the engine cylinder block and cylinder head, otherwise it is likely to cause the cylinder block due to sudden cooling and burst.

Please remember the above three points, otherwise it will be too late to bring harm to you or your roller.

Sprinkling water tank use matters needing attention: when the radiator is completely draining water and then injecting water, first twist the drain switch of the engine cylinder block, and then close it when there is water flowing out, so as to avoid blisters. In daily use, water level should be checked at any time, and water should be added after cooling down. When adding water, slowly open the water tank cover, and the operator's body should be far away from the water inlet as far as possible to prevent the high pressure steam from pouring out of the water outlet and causing burns.

Leave a Comment

Shopping Cart